-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueBreaking High-speed Material Constraints
Do you need specialty materials for your high-speed designs? Maybe not. Improvements in resins mean designers of high-speed boards can sometimes use traditional laminate systems. Learn more in this issue.
Level Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
Opportunities and Challenges
In this issue, our expert contributors discuss the many opportunities and challenges in the PCB design community, and what can be done to grow the numbers of PCB designers—and design instructors.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: Less than a minute
![](https://iconnect007.com/application/files/5817/0542/2681/Istvan_Novak_300.jpg)
Quiet Power: Cable Quality Matters
In my August column, we looked at the importance of properly terminating the cables that connect a measuring instrument to our device under test. We may be surprised to learn that even if we use the correct termination at the end of the cable, the measured waveform may depend on the quality of the cable we use.
To illustrate the point, we will use the same DC-DC converter evaluation board with an LTM4604 buck converter. To eliminate any possibility of ground loops, the converter is powered from a small battery pack with three AA batteries. The load is a small incandescent bulb, taking approximately 1A DC current from the output. We use a 50-ohm coaxial cable with BNC connectors at both ends. One end of the cable is connected to CH1 input of a Tektronix TDS540B oscilloscope. The input is switched to 50-ohm input impedance. The other end of the cable is connected to the BNC socket on the evaluation board, which directly monitors the output voltage. Read the full column here.Editor's Note: This column originally appeared in the October 2013 issue of The PCB Design Magazine.
More Columns from Quiet Power
Quiet Power: The Effect on SI and PI Board PerformanceQuiet Power: 3D Effects in Power Distribution Networks
Quiet Power: Noise Mitigation in Power Planes
Quiet Power: Uncompensated DC Drop in Power Distribution Networks
Quiet Power: Ask the Experts—PDN Filters
Quiet Power: Friends and Enemies in Power Distribution
Quiet Power: Be Aware of Default Values in Circuit Simulators
Quiet Power: Do You Really Need That Ferrite Bead in the PDN?